Redmond, King County
Creosote removal in Redmond is priced from $215. The amount depends on the stage of the deposit. Flaky soot comes off with a brush; a tarry layer needs rotary tools; a hard, shiny glaze takes a chemical treatment and sometimes a second visit. A camera shows us which one you have, and you get the price for that stage, in writing, before we begin.
Typical investment
From $215
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Redmond home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Redmond homes.
A Level 1 check, or a Level 2 with a camera run through the flue when the visible parts are not enough
Learn more
Brushing of the whole flue, top to firebox, with brush heads sized to the liner
Learn more
A photographed assessment that separates cosmetic wear from structural damage
Learn more
A camera run and full measurements before any liner is ordered
Learn more
Measurement of each flue, or of the full crown for a multi-flue cap
Learn more
Cleaning and testing of the burner, the pilot assembly and the ignition
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
Few Redmond homes heat with wood: the Census estimate is 72 households, about 0.2% of occupied units, with a margin of error nearly as large as the figure. A fireplace here is therefore rarely the main heat; it is lit now and then, for an evening. An occasional short fire seldom brings a flue up to temperature, and a flue that stays cool condenses smoke on its walls.
About a quarter of Redmond's housing, 25.9% in the Census estimates, was standing before 1980, most of it from the two decades after the town stopped being rural. A wood insert is one of the alterations a fireplace of that age may have received since.
FEMA's chimney advisory treats inserts and metal flues as the sound way to rebuild. An insert that was simply pushed into an old fireplace without a full liner is another matter: its smoke enters a wide, cold masonry flue and slows down, a setting that favors heavy deposit. Removal there starts with pulling the insert.
Every creosote removal we do in Redmond includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowFuel is the second factor. Washington's Department of Ecology sets a one-year minimum between splitting firewood and burning it, the stack kept covered throughout. Dry storage is the difficulty locally. In the Western Regional Climate Center's count, a winter month has somewhere from four to eight days without full cloud cover. Logs bought in October and left by the back door go into the fire wet, and wet wood is what builds glaze.
Redmond's hazard annex lists two faults near the city. By Washington DNR's dating, one of them last ruptured around 900 CE, in an earthquake estimated between magnitude 7.0 and 7.5; the other is the South Whidbey Fault.
The link to creosote is simple. If a tremor has opened a joint in the liner, a chimney fire is no longer contained by the flue. Burning deposit can then heat the masonry and whatever touches it. Taking the fuel off the walls removes one half of that risk, and the bare liner lets the camera look for the other half.
The camera run sorts the buildup into soot, tar or glaze, and locates it along the flue.
You get a written figure tied to what the camera showed.
Rotary heads matched to the liner material strip what can be stripped without harming tile or steel.
Where a hardened layer remains, a remover is applied that turns it brittle. It is brushed out once it has done its work, on a return visit when needed.
A final camera pass confirms a clean wall and lets us check the liner the deposit was hiding.
What this work is quoted at for Redmond homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Redmond | What that covers |
|---|---|---|
| Creosote Removal | From $215 | Priced by creosote stage — glazed stage 3 is the heavy end |
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Relining | From $1,900 | Full-length stainless liner, sized to the appliance |
| Chimney Repair | From $425 | Masonry repair — brick and mortar, scoped after diagnosis |
Ranges are what these jobs are quoted at in Redmond. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Chronic glaze is sometimes the appliance's fault: an old stove or insert that cannot burn cleanly. Replacing it is a permit matter. The Department of Ecology states that it does not regulate stove installation and leaves that to the local building permit office.
For a Redmond address, that office is the city's Development Services Center, and the mechanical permit application has a line for Wood Pellet Stove or Insert as well as one for Fireplace. We clean what you have; if the camera suggests the appliance is the cause, we say so and point you to the form.
Redmond is a city of a little over 17 square miles around the northern tip of Lake Sammamish, on the Sammamish River, with homes with a median build year of 1993, close to a quarter of them built in the 1960s and 1970s. We work every part of it — Education Hill, Grass Lawn, Idylwood, North Redmond, Overlake included.
RedmondKing County, WA · 47.674, -122.121
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
It starts at $215. Heavier stages cost more because they take stronger tools, a chemical treatment or two trips. The written quote names the stage.
Yes. A sweep removes loose soot. CSIA draws the line for masonry fireplaces at a sooty layer 1/8 inch thick, with any glaze a reason to act sooner, because glaze is the form a brush cannot shift.
The Puget Sound Clean Air Agency sets a ceiling at any time of year: 20 percent opacity, not to be exceeded for six consecutive minutes within an hour. The permitted fuels are manufactured logs and seasoned wood that is dry. Thick smoke is both a legal problem and a sign of the cool, wet burning that makes creosote.
If nobody has run a camera up the flue, yes: the evaluation is $99 plus tax. That charge is then subtracted from the removal quote you approve.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
