Redmond & the East Side, WA
Dryer vent cleaning in Redmond clears lint out of the entire exhaust run, dryer outlet to exterior hood, to restore airflow and remove a known fire hazard.
Our price
$105–$265
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing — we'll point you to the right fix.
What we do
Sweeping, inspection, relining and masonry — one local crew for the whole chimney.
A chimney inspection in Redmond tells you, with photos, what shape the flue, liner, crown, cap and flashing are in before you trust them with another season of fires.
Learn more
Chimney sweeping in Redmond clears out the soot and creosote last winter's fires left behind, and ends with a look at the flue once its walls are bare.
Learn more
Chimney repair in Redmond covers the structural work on a stack: loose or broken brick, failed joints, a leaning top, and rebuilds when patching is no longer honest.
Learn more
Chimney relining in Redmond gives a damaged or mismatched flue a new stainless steel liner, with a diameter chosen for the appliance that vents through it.
Learn more
Chimney cap installation in Redmond puts a stainless cover over the flue to keep rain, needles, birds and embers from passing through an opening that was never meant to be left bare.
Learn more
Gas fireplace service in Redmond cleans and tests the burner, pilot, glass and venting of a gas fireplace, insert or log set, so it lights when asked and vents where it should.
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
The lint screen catches part of what a dryer sheds; the rest travels into the duct and settles wherever the air slows down. Redmond has a housing mix that makes this worth attention: by the Census count, 27.3% of the city's housing units are in buildings of 50 or more units, and in an apartment or condo the laundry is often far from an outside wall. Long ducts with several bends collect lint faster. We clean the full run with rotary brushes and air, clear the exterior hood, and measure airflow at the end.
In Sammamish, where the Census classes 81.4% of housing as single-family detached, the usual trouble is different: a laundry room on the upper floor or deep inside the floor plan, and a duct that climbs through the attic to a roof vent. Vertical runs let damp lint settle back down the pipe, and a roof termination is one nobody checks from the ground. Those are the ducts where a yearly cleaning pays for itself.
Each year, by the U.S. Fire Administration's estimate, about 2,900 clothes dryers catch fire in American homes. The agency names failure to clean as the leading contributing factor, at 34 percent. It also finds that these fires peak in January.
Lint is fine, dry and quick to ignite, and a dryer supplies the heat. Washington's residential code is written to keep ducts short and smooth for that reason. A four-inch metal exhaust duct is limited to 35 feet, minus five feet for every 90-degree elbow; it must end outdoors, at least three feet from any opening into the building, with a backdraft damper and with no screen at the termination, since a screen is a lint trap. A gas dryer adds a second concern: its exhaust carries combustion gases, so a blocked duct can push carbon monoxide back into the laundry room.
How it works
We find where the duct runs, how many turns it makes and where it exits.
Rotary brushes loosen the lint and air carries it out to a collection point.
The outside hood is cleaned and its damper checked so it opens and closes.
Dryer on, airflow measured at the termination, results noted for you.
Licensed& insured Washington chimney contractor
4 communitiesRedmond, Sammamish, Duvall and Carnation
$99 plus taxInspection, credited toward an approved quote
Every jobDocumented with before-and-after photos
If any of these sound familiar, book the $99 plus tax inspection — credited toward the work if you approve the quote:
By town
The 4 East Side communities we serve. Pick yours for local scheduling and the chimney issues we see there.
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
Before you let anyone in
Every fact below is one you can check yourself before we ever set foot on your roof.
The on-site inspection is $99 plus tax, and it is credited toward the work when you approve the written quote. Booking online asks for no card.
You get the price in writing, for the work your chimney actually needs, and nothing starts until you have approved it.
Each item we inspect or repair is photographed before and after, so the condition of your chimney is on record.
Call (425) 470-6533 — a local East Side number, the same one on every page of this site.
Licensed& insured Washington chimney contractor
4 communitiesRedmond, Sammamish, Duvall and Carnation
$99 plus taxInspection, credited toward an approved quote
Every jobDocumented with before-and-after photos
Serving Redmond, Sammamish, Duvall & Carnation
For most homes, yes. A big household, pets, long duct runs and roof terminations are reasons to do it more often, and a load that takes two cycles is a reason to do it now.
Dryer vent cleaning is $105–$265. A short run through a ground-floor wall is the low figure; roof exits, second-story laundries and ducts packed with lint or a nest are the high one.
Yes. The state code does not allow screens at a dryer termination, because lint mats against them and blocks the duct. A hood with a damper flap keeps animals out without trapping lint. We can swap it.
Behind the dryer, a short listed transition hose is normal. For the concealed run, the code calls for smooth metal duct of at least 4 inches nominal diameter. Foil or plastic hose inside a wall or ceiling sags, catches lint and should be replaced.
Yes, for the duct that serves your unit, provided we can reach its termination. In some buildings the exit is on a wall or roof managed by the association, so it helps to check access with the manager before the visit.
See dryer vent cleaning pricing in detailMore chimney questions
Air duct cleaning in Redmond removes the dust and debris that settle inside a forced-air system's supply and return ducts, using sealed negative-pressure equipment.
Learn moreChimney sweeping in Redmond clears out the soot and creosote last winter's fires left behind, and ends with a look at the flue once its walls are bare.
Learn moreA chimney inspection in Redmond tells you, with photos, what shape the flue, liner, crown, cap and flashing are in before you trust them with another season of fires.
Learn more| Service | Price in Redmond | What that covers |
|---|---|---|
| Dryer Vent Cleaning | $105–$265 | Full run cleaned; roof or upper-floor terminations at the top |
| Air Duct Cleaning | From $525 | Whole HVAC system — trunks, branches and every register |
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
Ranges are what these jobs are quoted at in Redmond. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Licensed local crews, a $99 on-site inspection credited toward repairs, and a written quote before any work. Book a real open slot on our calendar.
